netflow configuration SUP2T
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-01-2012 01:42 PM - edited 03-07-2019 07:01 AM
Hi,
I have problem configuring Netflow on 6500/SUP2T : it seems that standard commands do not exist on that SUP (ex : ip flow xxx).
I tried to configure flexible Netflow too but it applies only to routed interfaces ...
Perhaps the commands have changed for that SUP (as for QOS commands).
I am really new to netflow configuration.
Can anyone help me ?
I need only the very basic commands to configure.
Thanks in advance
Caroline
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-01-2012 01:57 PM
Hi,
Sup 2T has actualy more Netflow capabilities than the older sups.
Here is doc with config example:
http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/white_paper_c11-652021.html
HTH
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-01-2012 02:10 PM
Hi Reza,
Actually, I have configured flexible netflow already but no way to apply the "ip flow monitor" configured to the interface if in switchport state, I don't know why ...
With routed interfaces (no switchport), the command passes.
Unfortunately, I have only switchport interfaces configured (no routing on the 6500).
Any idea ?
Anyway, I will try to redo the config, based on the documentation you provided.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-01-2012 03:38 PM
Hi Caroline,
Netflow does not work on IPBase in 12.2(50)SY versions. You either need IPServices or higher or run 15.0(1)SY release or later.
Best regards,
Andras
