03-30-2010 07:42 AM - edited 03-06-2019 10:23 AM
Is there any special commands to enable netflow on a 3640 router? Have tried to use they typical commands but they say they are not supported.
Solved! Go to Solution.
03-30-2010 08:01 AM
nshoe18 wrote:
IP Plus for the feature set. We are trying to export the netflow from an interface to solarwinds netflow. What wuld be the correct commands to accomplish this? I am actually remotely supporting another on this.
Have a look at the 12.2 netflow configuration guide which covers how to export the flows -
http://www.cisco.com/en/US/docs/ios/12_2/switch/configuration/guide/xcfnfc.html
Jon
Cisco are currently donating money to the Haiti earthquake appeal for every rating so please consider rating all helpful posts.
03-30-2010 07:52 AM
Did a quick check on Feature Navigator and it looks like all features sets should support Netflow for that IOS version.
What commands are you trying to use ?
What feature set are you actually running ?
Jon
03-30-2010 07:58 AM
IP Plus for the feature set. We are trying to export the netflow from an interface to solarwinds netflow. What wuld be the correct commands to accomplish this? I am actually remotely supporting another on this.
03-30-2010 08:01 AM
nshoe18 wrote:
IP Plus for the feature set. We are trying to export the netflow from an interface to solarwinds netflow. What wuld be the correct commands to accomplish this? I am actually remotely supporting another on this.
Have a look at the 12.2 netflow configuration guide which covers how to export the flows -
http://www.cisco.com/en/US/docs/ios/12_2/switch/configuration/guide/xcfnfc.html
Jon
Cisco are currently donating money to the Haiti earthquake appeal for every rating so please consider rating all helpful posts.
03-30-2010 08:06 AM
I can't find where netflow is supported on 12.2 on a router (other than 7500/7600). Cisco typically puts commands in before they actually do anything so it's plausible that the commands are there, but they do not enable netflow.
03-30-2010 08:02 AM
Here's a config that works for me. It will also allow you to veiw top-talkers via the CLI.
ip flow-export source Loopback0
ip flow-export version 5
ip flow-export destination 10.210.11.10 9191
ip flow-top-talkers
interface serial0/0
ip flow [ingress | egress]
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide