Hi guys,
I'm trying to enable netflow on my new 6509E with the sup2t, i put the follows commands:
sw(config)#mls netflow
sw(config)# mls flow ip full (don't support the command, it show me an error)
sw(config)# ip flow ingress layer2-switched vlan 500
int vlan 500
ip flow ingress
int gx/x
no switchport
ip add x.x.x.x
ip flow ingress
but when i write the command "sh mls ip" it doesn't show anything....mmmmm....is it missing something in the configuration???? what are the correct steps for enable netflow????
The IOS is
Image Version = Cisco IOS Software, s2t54 Software (s2t54-IPBASEK9-M), Version 15.0(1)SY
these are part of the show module command:
Mod Sub-Module Model
---- --------------------------- ------------------
1 Distributed Forwarding Card WS-F6K-DFC4-A
2 Distributed Forwarding Card WS-F6K-DFC4-A
3 Distributed Forwarding Card WS-F6K-DFC4-A
5 Policy Feature Card 4 VS-F6K-PFC4
5 CPU Daughterboard VS-F6K-MSFC5
6 Policy Feature Card 4 VS-F6K-PFC4
6 CPU Daughterboard VS-F6K-MSFC5
Thanks guys for your help
Best regards.