cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
110
Views
0
Helpful
0
Replies

Netflow - Switch recognizes the match command but it lacks options

Branislav9835
Level 1
Level 1

Hello, 

I have issue with my  Catalyst 4500 L3. I need to configure flexible netflow. The commands are recognized by the switch however I can not configure any match or collect settings - the match and collect statements are recognized but I can't configure any option:

core1(config)#flow record REC1
core1(config-flow-record)#mat
core1(config-flow-record)#match ?
% Unrecognized command
core1(config-flow-record)#match ipv4 source address
^
% Invalid input detected at '^' marker.

core1(config-flow-record)#?
 collect                            Specify a non-key field
 default                            Set a command to its defaults
 description                     Provide a description for this Flow Record
 exit                                Exit from Flow Record configuration mode
 match                            Specify a key field
 no                                  Negate a command or set its defaults

core1(config-flow-record)#

The switch is running on cat4500e-entservicesk9-mz.151-2.SG2.bin - I was not able to find any info. regarding some bugs or missing functionality.

0 Replies 0
Review Cisco Networking for a $25 gift card