Network switch SG550XG-8F8T16 port boot in Debug without software
I have 3 network switches, SG550XG-48T, SG550XG-24T and SG550XG-8F8T. The two first are configured and stacked together. The 3rd, SG550XG-8F8T doesn't want to boot in normal mode. I can't access it via its Web page and I can't ping its default ip address 192.168.1.254. When I connect through the Console port, I can see only a ">" character as prompt and only 2 commands are available, "debug" and "help". I don't know what's happen.
I reset to the default factory settings but the issue still remains.
I get the following error message when I was connected through the Console port :
If someone have an idea about this issue, it will be very nice. I'm not Cisco engineer. I just need to used this 3 switches to change the VLAN setting port from an small program trhough a Telnet connection.
Hello I am getting this following error and get ACTV, XPS and S-PWR LEDs amber then suddenly all LEDs are off: Booting...(use DDR clock 667 MHz)*** Coprocessor Unusable Exception ***PC = 0x00000000 00000000SP = 0x00000000 00000000Cause Reg...
Once Cisco DNA Center has provisioned the SD-Access devices to sites, the SD-Access fabric can be created. In the Cisco DNA Center UI, navigate to Provision > Fabric. This is where you create and manage your fabric domains and transits.]
Provision Discovered Devices
On the Cisco DNA Center UI, navigate to Provision page
Select the following devices and provision all the devices to Floor-1. During the provision workflow, Cisco DNA Center can only provision devices of similar family. We wi...