Switching

Hello All,   Trying to get around a simple problem that has issues.. Current setup [site A]; Perimeter Firewall>(/24 network)>Perimeter router BGP>ISP   What we plan to do is split /24 into two /25. Site A; Firewall>(212.1.1.0/25 network)>perimeter r...

Hi   I'm trying to get to the bottom of some issues experienced by my users, they are seeing network slowness on occasion and the only issue that I can find from a network perspective is out discards. Most stations are unaffected - this seems to be a...

Hi all, I have a ISR1811 (integrated service router), I wanto to use it in my home in my internet cable connection. I had setup it and can have internet connection only in LAN ports, on the wifi connection I don´t have internet, in my wifi devices I ...

Looking to disable the functionality of the USB port TYPE A for security purposes. For what I have read, hw-module xxx command is not supported in IOS XE 3.6.6. Amy recommendations?   Thank you

Apologies if this has been answered already, I have googled and cannot seem to find anything categorical! I am looking to clarify which license I would need to implement one OSPF instance per VRF, so in my current case this will be 2 VRF instances wi...

Hi All, I want to buy cisco layer 3 switch with 100/1000 ethernet ports . Which model buy? Guide me the specification of the layer 3 switches.

Hello Guys,   Please advise on this. i recently deployed DAI on switches in our network but what beats me is most Cisco IP phone (7821 and 7911) goes off which is now causing administration overhead for me as i have to recover ports from err-disabled...

Dear all, I would like to ask the following problem below. Normally Cat2960 series switch by default setup express is enable however the output of show setup express is not active.   Cat2960XR#sh startup-configstartup-config is not present   Cat2960X...

Hi Experts, I would like to know how a Cisco 6500 would process ARP packets from a switchport that is placed in a VRF. SW-01#sh run int gi1/3/2 | i vrf ip vrf forwarding A SW-01#SW-01#sh run int vlan 8 | i vrf ip vrf forwarding ASW-01# If a server co...

I have a WAN connection and a point to point connection installed at my site.  Currently all traffic routes out the WAN connection.  I want to configure the interface (where my PTP is connected) to route specific traffic.  Can I accomplish this on th...

hello: I configure a stack of 2960 xr switches with a username and password (using the secret password) Username XXXXX privilege 15 secret  but forgot to enter the : enable secret  xxxxx     as part of the configuration the problem is that I have...