02-16-2019 09:18 AM - edited 03-08-2019 05:21 PM
Hi all , I have cisco nexus 3K .. Im trying to read the traffic on Vlan interface ,, but i can't .. Is there any way to monitor or read the traffic on Vlan Interface ?
B-Nexus# sh interface vlan 225
Vlan225 is up, line protocol is up, autostate enabled
Hardware is EtherSVI, address is 0042.686d.ca63
Description: Basra BB Internet Address is 10.10.60.4/28
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 255/255, rxload 255/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA
Last clearing of "show interface" counters never
L3 in Switched:
ucast: 0 pkts, 0 bytes
02-16-2019 09:52 AM
Hi,
You can see the load on the physical interface.
sh int ex/x
you should see something like this
30 seconds input rate 50168 bits/sec, 1 packets/sec
30 seconds output rate 27626072 bits/sec, 2514 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 33.63 Kbps, 3 pps; output rate 24.28 Mbps, 2.15 Kpps
HTH
02-16-2019 10:24 AM
Thanks ... but i have 5 Vlan's trunk on this port ... i need to know the traffic pass through each Vlan .. Not total traffic for all these Vlan's
02-16-2019 10:55 AM
02-16-2019 12:09 PM
I do not belive you should able to view that.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: