01-25-2013 03:29 AM - edited 03-07-2019 11:18 AM
We are planning to implement the following policy map for egress traffic on an Nexus 7000:
policy-map type queuing dd-1p3q1t-8e-out-10G
class type queuing 1p3q1t-8e-out-pq1
priority level 1
shape percent 10
class type queuing 1p3q1t-8e-out-q2
bandwidth remaining percent 5
class type queuing 1p3q1t-8e-out-q3
bandwidth remaining percent 5
class type queuing 1p3q1t-8e-out-q-default
bandwidth remaining percent 90
We are using two N7K's to which is one N5K connected through a vPC. From the N5k we use a port-channel with 4 * 10G. Two of this four ports are connected to on N7K and the other two are connected to the other N7K. On the n/K's we are using vPC.
My question now are:
1. Where i have to connect the policy map? To the port-channel or on each physical interface?
2. When i have to connect this policy to the port-channel, how does i have to set the shape percent, when i would like to reserve 10% from the 40G?
Does i have to set the shape value to 5% on each N7K because vPC?
Kalle
Solved! Go to Solution.
01-25-2013 05:24 PM
You configure the policy-map on the port-channel interface.
You set it to 10% on both switch
01-25-2013 05:24 PM
You configure the policy-map on the port-channel interface.
You set it to 10% on both switch
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide