cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1020
Views
0
Helpful
1
Replies

Nexus 7000: "service-policy type queuing output" on port-channel and/or physical port

kfischbach
Level 1
Level 1

We are planning to implement the following policy map for egress traffic on an Nexus 7000:

policy-map type queuing dd-1p3q1t-8e-out-10G
    class type queuing 1p3q1t-8e-out-pq1
      priority level 1
      shape percent 10
    class type queuing 1p3q1t-8e-out-q2
        bandwidth remaining percent 5
    class type queuing 1p3q1t-8e-out-q3
        bandwidth remaining percent 5
    class type queuing 1p3q1t-8e-out-q-default
        bandwidth remaining percent 90

We are using two N7K's to which is one N5K connected through a vPC. From the N5k we use a port-channel with 4 * 10G. Two of this four ports are connected to on N7K and the other two are connected to the other N7K. On the n/K's we are using vPC.

My question now are:

1. Where i have to connect the policy map? To the port-channel or on each physical interface?

2. When i have to connect this policy to the port-channel, how does i have to set the shape percent, when i would like to reserve 10% from the 40G?
    Does i have to set the shape value to 5% on each N7K because vPC?

Kalle

1 Accepted Solution

Accepted Solutions

dominic.caron
Level 5
Level 5

You configure the policy-map on the port-channel interface.

You set it to 10% on both switch

View solution in original post

1 Reply 1

dominic.caron
Level 5
Level 5

You configure the policy-map on the port-channel interface.

You set it to 10% on both switch

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco