Nexus 7K N7K-F248XP-25E Issue

[himanshudwivedi]

I am using Nexus7000 C7009 (9 Slot) Chassis in my environment with N7K-F248XP-25E  installed on 3rd Slot. 

Since a week I am facing a issue that, full slot stop working after some period of time and status on the card has RED Indication. When I jack out and jack in the card It works for sometime and again goes down, can anyone tell me what is the exact issue.

[marce1000]

 - Probably an upcoming hardware problem, check the logs on the nexus server when this happens, or use a syslog-server as log-collector.

 M.

[balaji.bandi]

Can you post-show modules (sometimes you mixing with other modules may have an issue) - by saying most cases F2 cards should work.

Look at RED LED mean :

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/hw/nexus7000/installation/guide/n7k_hig_book/n7k_LEDs.html#47519

worth posting the logs while insertion to exit to understand what was the process and why it got an error.

[himanshudwivedi]

Currently I am unable to provide you show module output. 

In Down case I have noticed by using SH INV command, card is not showing in Slot 3 and interfaces are also not visible.

I have a log attached here, of slot 3. 

[balaji.bandi]

the output does not give any clue other than the interface going up and down on slot3

we need logs when you inserted and removed.

[marce1000]

 - The card is probably developing a hardware problem, you may have it replaced.

 M.

[himanshudwivedi]

Sir, 

Can I check by inserting the card in different slot...

[balaji.bandi]

You can try, either case we need to see more Logs ( when you insert the card capture the full logs)

along with show module information. 

if this production network as suggested raise a TAC case for RMA.

[MHM Cisco World]

I think no hard error
I think this is because the auto speed,
only config the Speed on this interface and see the result.
Hope this is the issue here.