cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

259
Views
0
Helpful
2
Replies
Beginner

Nexus IOS upgrade by setting boot var and reload

Hi,

With respect to bug in below link, Is there any way to check and confirm if the switch IOS had been installed by setting boot variable and reload instead of install all?

 

Bug: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuy08068/?referring_site=bugquickviewredir

 

Regards,

Godwin. S

2 REPLIES 2
Highlighted
Beginner

Re: Nexus IOS upgrade by setting boot var and reload

I am not sure how this can help you, but if you run 'sh ver', the last lines show you which the last version was and how it was upgraded (or downgraded)

Beginner

Re: Nexus IOS upgrade by setting boot var and reload

Other clue, if boot variables were set up and the switch reloaded, sometimes that doesn't update some firmwares (especially when the update is made it not following the right order of versions.) You can check it running 'show install all xxxx' and see if the version of the current firmware and the new one matches.

 

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards