12-13-2017 01:18 PM - edited 03-08-2019 01:06 PM
Hi,
With respect to bug in below link, Is there any way to check and confirm if the switch IOS had been installed by setting boot variable and reload instead of install all?
Bug: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuy08068/?referring_site=bugquickviewredir
Regards,
Godwin. S
12-13-2017 02:01 PM
I am not sure how this can help you, but if you run 'sh ver', the last lines show you which the last version was and how it was upgraded (or downgraded)
12-13-2017 02:09 PM
Other clue, if boot variables were set up and the switch reloaded, sometimes that doesn't update some firmwares (especially when the update is made it not following the right order of versions.) You can check it running 'show install all xxxx' and see if the version of the current firmware and the new one matches.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide