cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
821
Views
0
Helpful
1
Replies

nexus7000: 1 powered-dn Unknown card (Could not get software-card-id)

nilsahu
Level 1
Level 1

Hi,

   I'm running n7000 image 5.2.7 on my nexus 7000 box. The module 1 does not come up. The LC is N7K-M148GS-11L. The card requires Cisco NX-OS 5.0 or above.

Please let me know if some information is available on this. "show module" output is as below:

switch# show mod

Mod  Ports  Module-Type                         Model              Status

---  -----  ----------------------------------- ------------------ ----------

5    0      Supervisor module-1X                N7K-SUP1           active *

6    0      Supervisor module-1X                N7K-SUP1           ha-standby

Mod  Sw              Hw

---  --------------  ------

5    5.2(7)          3.0    

6    5.2(7)          3.0    

Mod  MAC-Address(es)                         Serial-Num

---  --------------------------------------  ----------

5    d8-67-d9-03-73-f0 to d8-67-d9-03-73-f8  JAF1624AGTH

6    d8-67-d9-03-99-98 to d8-67-d9-03-99-a0  JAF1624AJBG

Mod  Online Diag Status

---  ------------------

5    Pass

6    Pass

Xbar Ports  Module-Type                         Model              Status

---  -----  ----------------------------------- ------------------ ----------

1    0      Fabric Module                       N/A                powered-dn

2    0      Fabric Module                       N/A                powered-dn

3    0      Fabric Module                       N/A                powered-dn

Xbar Power-Status  Reason

---  ------------  ---------------------------

1    powered-dn     Unknown card (Could not get software-card-id)

2    powered-dn     Unknown card (Could not get software-card-id)

3    powered-dn     Unknown card (Could not get software-card-id)

Xbar Sw              Hw

---  --------------  ------

Xbar MAC-Address(es)                         Serial-Num

---  --------------------------------------  ----------

* this terminal session

Thanks,

Nilesh

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

Why are your FAB-1 cards powered down?


What do you see in the "sh logs"?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco