cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
466
Views
0
Helpful
1
Replies

NHRP stops working after IOS Upgrade

jpeterson6
Level 2
Level 2

Hi,

When running IOS version 15.2(2)T1 on a particular DMVPN spoke (Cisco 881W-GN-A-K9), I'm able to establish a connection to the DMVPN - NHRP works, EIGRP works - no issues.

When I tried upgrading to 15.2(4)M5, NHRP no longer connects to the hub from that spoke, but I can still ping the external IP gateway of the hub router just fine. The ISAKMP and IPSEC connection establish:

IPv4 Crypto ISAKMP SA

dst                      src                     state          conn-id status

xxx.xxx.xxx.xxx  xxx.xxx.xxx.xxx QM_IDLE           2004 ACTIVE

xxx.xxx.xxx.xxx  xxx.xxx.xxx.xxx  QM_IDLE           2003 ACTIVE

The 'show ip nhrp nhs detail' command produces:

Legend: E=Expecting replies, R=Responding, W=Waiting

Tunnel0:

10.200.0.1   E priority = 0 cluster = 0  req-sent 22  req-failed 0  repl-recv 0

Tunnel1:

10.200.1.1   E priority = 0 cluster = 0  req-sent 22  req-failed 0  repl-recv 0

I verfied connectivity to the hub's external IP address so I know there's no issue there. Tunnel Encryption seems to work fine.

When I downgrade back to the previous version, the Tunnel/NHRP/EIGRP comes back up right on boot with no trouble.

Any thoughts? I could use a good suggestion here.

Thanks,

JP

1 Reply 1

jpeterson6
Level 2
Level 2

Anyone have any insight? I'm still having this issue and haven't had any luck with it.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: