No data on RSPAN Destination port

[denise.fyffe]

Quick question.

Should I be able to see the counters increment on a RSPAN monitoring port, see the example below, I have two destination ports going into ISE.  I have been having trouble with DHCP profiling.

I checked that all connections were up for the RSPAN port (its listens to the DHCP server on a different switch)

However, the destination ports on the Switch which hosts ISE, show no data, is this normal?

Session 2
---------
Type                   : Remote Destination Session
Source RSPAN VLAN      : 900
Destination Ports      : Gi1/0/29-30
    Encapsulation      : Native
          Ingress      : Disabled

GigabitEthernet1/0/29 is down, line protocol is down (monitoring)
  Hardware is Gigabit Ethernet, address is 68bd.abc2.631d (bia 68bd.abc2.631d)
  Description: Cisco ISE Primary RPSAN port
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto-duplex, Auto-speed, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output 25w4d, output hang never
  Last clearing of "show interface" counters 16w1d
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts (0 multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out
sh int gi1/0/30
GigabitEthernet1/0/30 is down, line protocol is down (monitoring)
  Hardware is Gigabit Ethernet, address is 68bd.abc2.631e (bia 68bd.abc2.631e)
  Description: Cisco ISE secondary RPSAN port
  MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto-duplex, Auto-speed, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output never, output hang never
  Last clearing of "show interface" counters 16w1d
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts (0 multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out

[ADP_89 · Accepted solution]

Hello,

To me it looks like your 2 ports are physically down, you should have something like this:

GigabitEthernet1/0/29 is up, line protocol is down (monitoring)

HTH,

ADP

[denise.fyffe]

Went to site to find both interfaces with no link lights on the back of the ISE boxes.  Replaced cables, and connection restored.

thank you

GigabitEthernet1/0/29 is up, line protocol is down (monitoring)
  Hardware is Gigabit Ethernet, address is 68bd.abc2.631d (bia 68bd.abc2.631d)
  Description: Cisco ISE Primary RPSAN port
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 1000Mb/s, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output 02:13:10, output hang never
  Last clearing of "show interface" counters 16w1d
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 373000 bits/sec, 200 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts (0 multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     0 input packets with dribble condition detected
     1535859 packets output, 358019233 bytes, 0 underruns
     0 output errors, 0 collisions, 2 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out
#sh int gi1/0/30
GigabitEthernet1/0/30 is up, line protocol is down (monitoring)
  Hardware is Gigabit Ethernet, address is 68bd.abc2.631e (bia 68bd.abc2.631e)
  Description: Cisco ISE secondary RPSAN port
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 1000Mb/s, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output 02:00:11, output hang never
  Last clearing of "show interface" counters 16w1d
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 270000 bits/sec, 115 packets/sec
     2 packets input, 176 bytes, 0 no buffer
     Received 2 broadcasts (0 multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 2 multicast, 0 pause input
     0 input packets with dribble condition detected
     806557 packets output, 234926540 bytes, 0 underruns
     0 output errors, 0 collisions, 2 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out

[balaji.bandi]

Can you post the configuration to review.