cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

128
Views
0
Helpful
3
Replies
Highlighted
Beginner

No Internet After Creating VLAN

New to this so please be patient.  :)

I created a simple vlan on an SG350 .  Port 1 connected to Edgerouter.  Port 2 connected to WAP.  Port 3 connected to laptop1 (VLAN2) and Port 4 connected to laptop2 (VLAN3).   No internet access on either laptop.  I assume port 1 should be setup as a trunk.  I had this running before but had to reset the router and now I don't remember how it was configured.

3 REPLIES 3
VIP Advisor

Re: No Internet After Creating VLAN

Hi there,

what model is your edge router? If it is a simple ISP supplied item then you may run into trouble with your setup.

 

the issue you are probably experiencing is that although the SG350 is correctly routing between your VLANs the edge router has no idea how to reach devices in VLANs 2 and 3. This can be remedied by adding a static routes for these VLANs to the edgerouter with a next-hop as the SG350 VLAN1 IP address.

If the edge router cannot have static routes configured, then you need to NAT VLANs 2 and 3 behind VLAN1, however the SG350 does not support NAT. You need another router or firewall for that.

 

cheers,

Seb.

Rising star

Re: No Internet After Creating VLAN

Hi there,

firstly share your configuration on switch and edrouter (if you have access on it). I think that your edrouter is simple and is configured just to allow one network, in your case... network on port 1.

I have two idea:
1. Check if your router support create a nat to this other two networks, if yes, configure it and create a route back from your edrouter to your sg350 for all networks, vlan 2 and 3.
2. If your router doesnt support nat configuration, you will need a firewall to controll traffic.
Jaderson Pessoa
*** Rate All Helpful Responses ***
Beginner

Re: No Internet After Creating VLAN

Thanks for the replies!   I have to stress that I’m new to this switch and setting up vlans.  At this point I just want to confirm I have the VLAN configured properly which looks like I do.  However, I’m not sure about the settings for the port connected to the router.  Should it be a trunk?  Tagged or untagged.  The router is an Edgerouter X.   

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards