I have an issue with one of my switch ( 4500 series) .
We have a server which has two interfaces and each assigned with an IP address ( in the range[10.49.8.132/27]) . Eth0 IP:10.49.8.135 and Eth1 IP:10.49.8.136 . Eth0 is connected to Switch-A and Eth-1 is connected to Switch-B . When tried to ping Eth0 IP it is success from switch-A whereas Eth-1 is not a success. Now the same IP's are pingable from the other switch-B . I am not sure what might be wrong . Please advise .
I checked the config.. files looks good .
could you please give a try .
default gateway for your system to use Switch virtual interface NOT HSRP Virtual ip address
I hope you understand my question . .
this is my mobile number 91+9618613678
As I discussed.
If it is possible to try to upgrade your IOS Version to latest .
because both version are different .
Your config looks fine, from what external source are you trying to ping it? is the 2nd NIC on the server configured with a gateway?
If they are on the same subnet they will be able to ping each other without gateway configured on the NICs.
Thank you, But Im referring if both NICs are configured with the gateway:
These switches seemed to be separate and not stacked or visualized
In a virtual stack link aggregation can span two switches as the server will see it a just one switch, However if the switch isnt "stacked" then the server connections need to be on the same switch in a link aggregation setup.(LACP) which I also don't see in you configuration.
I cannot comment on your server and its teaming software but having a server connected to two separate switches sharing the same address range and default-gateway and without any aggregation setup isnt really feasible.