02-09-2019 03:56 AM - edited 03-08-2019 05:17 PM
Hello,
ı am using sg-300 10 p poe switch for 3 fixed and 2 ptz axis cameras. But ı am getting not enough power for both camera and pan tilt motors any solution there?
02-09-2019 04:06 AM
Hello,
the most you can do is set the ports to class 4 power (30.0 Watt), have a look at page 222 of the attached user guide:
02-09-2019 07:58 PM
For sg-300 these setting arent aviable . I cant change class as 4 . And ı cant set power . It is really tertibble . Have you expirince before same isssu?
02-09-2019 06:48 AM
02-09-2019 12:34 PM
I have faced this problem in the past, and resolved it by running lldp.
In global config mode;
lldp run
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide