NXOS 'archive log config' equivalent?

[firemtngems]

Hi,

I'm running NXOS 5.1.1 on a N7010.  This is a new switch and I am looking for a feature to log config directives (like in the IOS via 'archive log config' command).  Is there such a thing?  If so, how?

Thanks,

Mike

[phiharri]

Hi Mike,

'show accounting log' displays the local accounting log which contains a quite substantial history of commands entered in both exec and config mode. You could use 'show accounting log | i 'configure terminal'' to display only config changes.

Hope this helps,

/Phil

[firemtngems]

Thanks Phil, that is helpful.  I also need to get it off to a syslog server.  Can that be done?

Mike

[phiharri]

Hi Mike,

For logging config changes other than on the switch itself your best bet would be setting up proper AAA accounting to a TACACS+ or RADIUS server, I can't think of any way you'd get this off via syslog.

Cheers,

/Phil

[mgaven]

Hello Mike, are you solved that issue?

In what way?

Thanks.-

[firemtngems]

You need to setup AAA accounting to capture this.  That means TACACS or RADIUS.

Cheers,

Mike

[mgaven]

Can´t I do this sending a log to my syslog server?

I centralize all the logs on a Prime LMS server and wish keep that.

Thanks

[firemtngems]

No but, LMS along with DFM, HUM and all that will work.

This link describes AAA accounting, if you really want to persue it.  I'm not a TACACS user but there that approach too.

http://www.cisco.com/en/US/docs/ios/sec_user_services/configuration/guide/sec_cfg_accountg.html

For me?  I am with you, I don't know why Cisco changed this in NXOS, it worked fine using syslog.

Good luck,

Mike

[mgaven]

Thanks!

[surfr111999]

Have you found a way to send the config commands to a syslog server? I am having the same issue. Our strategy works fine for IOS but the aaa accounting on NXOS is not what we need.

Any hint would be helpful :-)

[mgaven]

No way! The TACACS solution explained by Mike is a partial solution if you need that.

Good luck.

[shjones]

I'd recommend getting your TACACS or RADIUS server to send the messages to syslog, if you haven't already solved it in another way.

[STEPAN JANKOVIC]

Hello,

just for documentation purpose - for NXOS, this should help:

logging level aaa 6