05-21-2012 01:36 PM - last edited on 03-25-2019 04:19 PM by ciscomoderator
Hi,
With cost command ' ip ospf cost X ' on interface, it will affect all the network subnet's cost comming via that interface.
So, is there any way that we can change the cost of selected network subnet in OSPF ?
Pls ask is any more information needed....
Waiting for the responce.
Regards,
Kunal
Solved! Go to Solution.
05-21-2012 01:50 PM
Kunal
While some routing protocols such as EIGRP or RIP do allow you to manipulate the metric for particular routes this is not possible in OSPF. This derives from the principles of Link State Protocols which use Link State Updates to create a topology map of the network. To be able to draw the map accurately all the routers within the area must have the same topology information. This results in the fact that you can not change the metric for a particular route in the routing table.
HTH
Rick
05-21-2012 01:50 PM
Kunal
While some routing protocols such as EIGRP or RIP do allow you to manipulate the metric for particular routes this is not possible in OSPF. This derives from the principles of Link State Protocols which use Link State Updates to create a topology map of the network. To be able to draw the map accurately all the routers within the area must have the same topology information. This results in the fact that you can not change the metric for a particular route in the routing table.
HTH
Rick
05-22-2012 03:44 PM
Thanks Richard.
05-23-2012 06:41 AM
Kunal
I am glad that my answer was helpful to you. Thank you for using the rating system to mark the question as answered (and thanks for the points). It makes the forum more useful when people can read a question and can know that a correct answer was found. Your marking has contributed to this process.
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: