Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Can a Cisco SG300-10P switch power a Cisco SG200-08 switch over POE?  Or an SG200-08P power an SG200-08 via POE?  I have an area where I'd like to put a small switch, but would like to avoid having to have electrical power run to it.  Or will the SG3...

jeffdavis by Level 1
  • 1943 Views
  • 4 replies
  • 0 Helpful votes

Hi,I want to connect WS-C2960S-48TD-L switch to WS-X6708-10G-3CXL module in Cisco WS-C6503-E switch. WS-X6708-10G-3CXL is C6K 8 port 10 Gigabit Ethernet module with DFC3CXL which requires X2 module. on the otherhand, WS-C2960S-48TD-L requires SFP+. N...

Hi All!My question is about deploying MacSec over L2 MAN provider.I have HQ office and some Big office linked via MAN provider VLAN(X). Same provider provides L3 MPLS service with other VLAN(Y) for low speed far shops and offices.  Can I use MACSEC o...

Hi everybody.My book says " A campus network is an enterprise network consisting of many lans in one or more buildings, all connected and usualy in the same geographic area.Campus network commonly consists of ethernet.802.11 wireless lan,high speeds ...

sarahr202 by Level 5
  • 6283 Views
  • 9 replies
  • 0 Helpful votes

Hi guys,I have a 3750 switch with IP routing enabled and have lots of VLANs configured on this switch.What is the best way to prevent VLANs from talking to each other?At the same time, hosts inside their respective VLANs should not be blocked from re...

I just purchased a 1941w router to see if we want to use this to replace our existing routers and external access points. At each of our locations we have 1  subnet that has a server, AP, router, switch, etc. I would like to configure the AP and the ...

Hi All,I have few questions regarding the Cisco 3750X.1. Maximum number of ARP table entries supported2. Maximum IPv4 unicast routes and multicast routes supported in hardware.3. Maximum IPv6 unicast routes and multicast routes supported in hardware....

Resolved! K values

Hi all,I have a question on K values used in eigrp routing...It is said that to form a neighborship, k values must be the same; Is it necessary that K values weight must be same??eigrp by default uses k1 and k3 i.e. bandwidth and delay with weight 1....

I am having some problems on my SAN, which is reporting problems with network connectivity.  I am attempting to determine whether the error is the switch, interface, controller, cables, etc.  One of the ports connected to this SAN reported input erro...

Dear All,I am sorry for this silly question we need to relocate our core switch 6500 with sup 720 to another bldgwhat is the command to gracefully shut it downI mean power offI was told one can just switch off the powerbut i just wanna be carefulappr...

Unanswered Topics