cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
639
Views
15
Helpful
3
Replies

OSPF Load-sharing

udo.konstantin
Level 1
Level 1

Hi,

Currently I configure two catalyst 4506E as the Core OSPF router.

I know ospf will do per default equal load-Balancing. Also I know this load-balancing depends on the switching mode. In our case this is CEF and should be done per-Destination. I think it's possible to change e load-balancing to per-packet !!

Because normally if the load-balancing done with per-destination it is possible the links are not really utilized?! So I will change it to per-packet load balancing.

How can this changed on the catalyt 4506E switch ?

Thanks

Sent from Cisco Technical Support iPad App

2 Accepted Solutions

Accepted Solutions

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Udo,

in CEF the IP flow is defined by IP source address and IP destination address.

a boolean EXOR of last meaninglful bits of IP SA and IP DA and an hash seed that changes only at reload is used to assign flows to equal cost links.

IF traffic is made of multiple distinct  IP flows load sharing works well with load spread on the equal cost parallel links.

As noted by Alain load balancing per packet is not recommended because it can cause out of order issues.

I even wonder if the command is available on a multilayer switch like yours

Hope to help

Giuseppe

View solution in original post

Hi Giuseppe,

indeed it seems it is not supported as far as my search has  resulted.

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

View solution in original post

3 Replies 3

cadet alain
VIP Alumni
VIP Alumni

Hi,

this is highly discouraged to do per-packet load-sharing especially if you are using udp based applications or have a firewall

in the path because firewalls don't like assymetric routing too much. But anyway the command is under the interface:

ip load-sharing per-packet

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Udo,

in CEF the IP flow is defined by IP source address and IP destination address.

a boolean EXOR of last meaninglful bits of IP SA and IP DA and an hash seed that changes only at reload is used to assign flows to equal cost links.

IF traffic is made of multiple distinct  IP flows load sharing works well with load spread on the equal cost parallel links.

As noted by Alain load balancing per packet is not recommended because it can cause out of order issues.

I even wonder if the command is available on a multilayer switch like yours

Hope to help

Giuseppe

Hi Giuseppe,

indeed it seems it is not supported as far as my search has  resulted.

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
Review Cisco Networking for a $25 gift card