Packet does not go from ECMP on IOS XRV 6.1.3

[htainlynnaung199694856]

Hi Everyone..

Have a good day..

I am testing XRV 6.1.3 with the OSPF routing protocol as below in the topology. R1-R4 connection is considered. When I do "show IP route" and "show cef 4.4.4.4/32", it shows both routes but when I trace to 4.4.4.4, it only goes from one route. Results can be seen in the second pic. May I know how can I solve it? Thank you. 

 TopologyOutput of Show commands

[MHM Cisco World]

cef is per destination load balance,

hence you trace same destination you will get same result, 

try ip cef distribution and see result.

[htainlynnaung199694856]

Thanks for your reply. I am really appreciated your help. 

May I know the command to see the result for "IP cef distribution" ?

As I am trying to type that command, there is no command like that in IOS XRV. 

[MHM Cisco World]

https://www.cisco.com/c/en/us/td/docs/ios/12_4t/ip_switch/configuration/guide/tceflbs.html#wp1046601

check this doc. how to change from per-destination to per-packet.