cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
417
Views
10
Helpful
2
Replies
Highlighted
Beginner

Packet Tracer Question

I just found Packet Tracer today and it's a great tool to help me study. But one of the first things I noticed is I cannot do a show run int xxxxx command. I thought perhaps it was a IOS version issue so I did the upgrade to version 15 and still a no-go.

This would be extremely helpful as I get a more complex configuration going. any ideas why it doesn't work or how to get it to work?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Collaborator

No, its doesn`t work on packet tracert. Some features dont works well on packet tracer. Otherwise, you can use other features, like EVE-NG, GNS3 or VIRL.

EVE-NG: https://www.eve-ng.net/downloads
GNS3: https://www.gns3.com/
VIRL: https://dcloud.cisco.com/

Best regards

Rate all post that were help you.
Jaderson Pessoa
*** Rate All Helpful Responses ***

View solution in original post

2 REPLIES 2
Highlighted
VIP Collaborator

No, its doesn`t work on packet tracert. Some features dont works well on packet tracer. Otherwise, you can use other features, like EVE-NG, GNS3 or VIRL.

EVE-NG: https://www.eve-ng.net/downloads
GNS3: https://www.gns3.com/
VIRL: https://dcloud.cisco.com/

Best regards

Rate all post that were help you.
Jaderson Pessoa
*** Rate All Helpful Responses ***

View solution in original post

Highlighted

Hi @dalbright1 ,

 

In PacketTracer, to see the settings in an interface you can use these commands:

#show running-config

#show ip interface brief

#show ip interface gigabitEthernet 0/0

#show interfaces gigabitEthernet 0/0

 

Regards

Content for Community-Ad