PBR and SVI interface problem

[arumugasamy]

Team,

I'm facing the problem explained below to one of our customer

switch 6807 VSS Pair.

s2t54-adventerprisek9-mz.SPA.151-2.SY5.bin

VLAN 2 SVI 192.168.1.0/24

PBR to route some of the IPs to the next hop of different ISP.

Everything was working fine for long time but suddenly yesterday vlan 2 stop working and all the vlan 2 users lost the network access.

After removed the PBD (ip policy route-map) from the SVI interface, vlan 2 starts working. we applied then the PBR again expecting that the problem re-occur again but it is working. Customer wants report on it why after reapply the PBR vlan 2 is working.

Please give me your suggestions.

Thanks

[Georg Pauwen]

Hello,

I checked for bugs, the below is the only one I could find. What does your PBR look like, can you post the config ?

normal forwarding happens when config set ip next-hop under PBR
CSCva45619
Description
Symptom:
At C6807-XL (VS-SUP2T-10G) VSS running 15.1(2)SY7,normal forwarding happens when config set ip next-hop + ip address under PBR

Conditions:
C6807-XL (VS-SUP2T-10G) VSS
set ip next-hop+ip address under PBR

Workaround:
add config of set interface + egress port

Further Problem Description:

Customer Visible

Notifications

Save Bug

Open Support Case
Was the description about this Bug Helpful?(0)
Details
Last Modified:
Nov 14,2016
Status:
Open
Severity:
3 Moderate
Product: (1)
Cisco IOS
Support Cases:
3
Known Affected Releases: (1)
15.1(2)SY7.1

[arumugasamy]

Dear 

Thank you for your reply

I advised customer to upgrade to ver 15.1(2)SY9 which found no vulnerability under cisco.com/security

IOS checker

I send your response to customer.

Thx

[alieson]

Dear,

can you please update about the case?

Did the upgrade solve the issue?

[alieson]

im in version Version 15.2(1)SY6 and facing same issue for 6509 VSS