I have a c3560e-universalk9-mz.122-55.SE5.
I have 3 distinctive Vlan's:
Vlan 100: 10.8.33.0/24
Vlan 200: 10.8.133.0/24
Vlan 300: 10.8.233.0/24
Inter vlan routing is working.
My default gateway is 10.8.33.254.
I need to send some traffic in vlan 100 the rest has to go through their respctive vlans.
For instance. 10.8.133.1 has to connect 192.168.100.1 throught 10.8.33.254, but the rest of traffic must go to a gateway in 10.8.133.1.
PBR is suppose to solve my problem, but on interface vlan 100 or the other the ip policy comand is missing.
XXX(config-if)#ip ?
Interface IP configuration subcommands:
access-group Specify access control for packets
accounting Enable IP accounting on this interface
address Set the IP address of an interface
admission Apply Network Admission Control
auth-proxy Apply authenticaton proxy
authentication authentication subcommands
bandwidth-percent Set EIGRP bandwidth limit
broadcast-address Set the broadcast address of an interface
cef Cisco Express Forwarding interface commands
cgmp Enable/disable CGMP
dampening-change Percent interface metric must change to cause update
dampening-interval Time in seconds to check interface metrics
dhcp Configure DHCP parameters for this interface
directed-broadcast Enable forwarding of directed broadcasts
header-compression IPHC options
hello-interval Configures EIGRP-IPv4 hello interval
helper-address Specify a destination address for UDP broadcasts
hold-time Configures EIGRP-IPv4 hold time
igmp IGMP interface commands
information-reply Enable sending ICMP Information Reply messages
irdp ICMP Router Discovery Protocol
load-sharing Style of load sharing
local-proxy-arp Enable local-proxy ARP
mask-reply Enable sending ICMP Mask Reply messages
mroute-cache Enable switching cache for incoming multicast packets
mtu Set IP Maximum Transmission Unit
multicast IP multicast interface commands
next-hop-self Configures EIGRP-IPv4 next-hop-self
ospf OSPF interface commands
pim PIM interface commands
probe Enable HP Probe support
proxy-arp Enable proxy ARP
rarp-server Enable RARP server for static arp entries
redirects Enable sending ICMP Redirect messages
rgmp Enable/disable RGMP
rip Router Information Protocol
route-cache Enable fast-switching cache for outgoing packets
rtp RTP parameters
sap Session Advertisement Protocol interface commands
security DDN IP Security Option
split-horizon Perform split horizon
sticky-arp Allow the creation of sticky ARP entries
summary-address Perform address summarization
tcp TCP interface commands
unnumbered Enable IP processing without an explicit address
unreachables Enable sending ICMP Unreachable messages
urd Configure URL Rendezvousing
verify Enable per packet validation
Solutions?
