06-12-2023 07:36 AM
I recently replaced a Netgear 48 port switch with a cisco CBS220-48T-4G Switch. I have 3 PCs that lose their IP config after waking up from sleep. The PCs do acquire an IP configuration after about 30sec. Very annoying to wait 30sec. for this before I can access the internet or any other shared devices on the LAN. This has never happened before with the Netgear switch. Is there a setting that I can set in the GUI to keep this from happening? I have the (Energy Efficient Ethernet) disabled.
Solved! Go to Solution.
06-12-2023 08:09 AM
NOTE:- this feature must enable only in interface connect to host not port connect to other SW.
06-12-2023 07:41 AM
I dont know alot about CBS220 but config port connect to PC with port-fast this will faster open port and make PC get IP from DHCP quickly
06-12-2023 07:46 AM
Sorry, I don't see where in the GUI to set the port-fast option.
06-12-2023 07:53 AM
For small business SW in GUI I think this option under the spanning tree tab
If you can not find it try use cli
06-12-2023 07:56 AM
Under spanning tab I see Fast Link . Could this be it?
06-12-2023 08:09 AM
NOTE:- this feature must enable only in interface connect to host not port connect to other SW.
06-12-2023 02:29 PM
All good now! Thank you MHM Cisco World
06-12-2023 02:49 PM
You are so welcome
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide