cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
282
Views
5
Helpful
2
Replies

Physical int vs port channel

ahmad1982
Level 1
Level 1

Hello, 

in etherchannel config, which is better to apply commands such :

         Switchport tr na vl 1

         Switchport trunk encapsulation dot1q

         Switchport mode trunk

        Switchport tr allowed vl x,y

under port-channel or the physical interfaces? Or its the same? Or depends on the model?

 

thank you

ahmad

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame
Hall of Fame

Hi Ahmad,

Once you create a Portchannel, add the physical Interfaces to it and it is up and running, from that point you should add the configs to the Portchannel. Once you add the config to the Portchannel, the physical interfaces with inherit the config.

HTH

View solution in original post

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Hi Ahmad,

Once you create a Portchannel, add the physical Interfaces to it and it is up and running, from that point you should add the configs to the Portchannel. Once you add the config to the Portchannel, the physical interfaces with inherit the config.

HTH

ahmad1982
Level 1
Level 1
Thanks
Review Cisco Networking for a $25 gift card