Switching

Hi,I have two RV042 Dual WAN router. The current IP Address range is 192.168.100.1 - 192.168.103.254 / 22. We have extended LAN, 500 IP's in one premises in another 500 in another premises, but all are in the same subnet. Both premises are connected ...

I have questions as this my first enterprise level cisco router 1941.  I purchased it orginally due to the intigrated security features such as the ability to span ports and run a sniffer as well as some of the other features.  However I realized aft...

The Switch 2960X support limited layer 3 features as static routing, if has the capability to read layer 3 and route packets, then should be recognized as a Basic Layer 3 switch?The configuration guide says that it could support static routing and de...

Hello everyone,        Could IPv4 PBR feature deploly on Nexus 3548P switch ? I configured PBR feature on my 3548P switch , but it did not work as expect as on IOS platform  , the configuration present to you as follow, the special packet flows can n...

Hi All,I had an issue where the multicast streams being published took over 4mins to recover when an HSRP failover occured.Now I know PIM is independent of HSRP and that the multicast streams were being forwarded by the standby router, so the dropof ...

Hi everyone! I'm configuring a Cat4500 with IOS XE 3.5 and the command  "switchport trunk encapsulation dot1q" it's being rejected, apparently the command " switchport trunk encapsulation" is not supported, but I have being looking in the Configurati...

hi people? I want to buy a cisco switch from a reseller. how do I know if it's original just by looking at it?

Hi,i'm kinda neebie in cisco devices, thats why im wasking help.This is what i have to do for one of my customers.My problem is i dont know what router to choose. There're 3 subnets ->192.168.1.X (called A)192.168.192.X (called B)10.101.10.X (called ...

Hi, never done this before...I need to order a UPS for a 48 port, 3750X PoE switch. The switch has 2, 750Watt power supplies.Of course, one of the power supplies is redundant so, I only need enough to power to keep the switch and all of it's phones r...

Hello,I am configuring a new acces for telnet,first,Switch asks me username and password,after he askes me again "enable password",But I want it enters directly without asking me "enable password" besown my config::Building configuration...Current co...

When we configure ether channels on switches the ports are shown up at layer 1 and layer 2. So how does it prevents formation of loop in ports at physical layer in case if the packet comes back. The  spanning tree thinks it as a single bridge port.