%PLATFORM_UCAST-4-PREFIX: One or more, more specific prefixes could not be programmed into TCAM and are being covered by a less specific prefix, and the packets may be software forwarded
Hello - We are using a 2960 XR as DHCP server for our guest wireless network and recently increase our scope because we were running out of ip addresses. After doing this we began receiving the above message and users are complaining of sluggish internet perfomrace. I have read about changing the SDM template but it seems this is related to routing. We are using this switch only as DHCP server and are not routing at all. My question is if I change the SDM template to "SDM prefer VLAN" would that help my issue? This would be only temporary until we get a more permanent solution. Thanks in advance. Frank
To participate in this event, please use the button to ask your questions
* Note: The link to join the discussion will be activated on March 8
All the knowledge of these four experts at your disposal!
Cisco Software-Defined Wide Area Network (SD-WAN...
Community Live- ISR1100X-4G and ISR1100X-6G Platform Overview and Architecture
(Live event - Tuesday, 23 March, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event will have place on Tuesday 23rd, March 2021 at 10:00 hrs PDT&...
Cisco Secure Network Access is helping IT to bridge the gap between what is essential to the business and what the network delivers and to build the next-generation campus network for an unplugged and uninterrupted experience.
Learn more about how these w...
(view in My Videos)
Community Live- New Additions to the Catalyst 8000 Family
(Live event - Tuesday, 23 February, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event had place on Tuesday 23rd, February 2021 at 10:00 hrs PDT...
This event had place on Tuesday 23rd, February 2021 at 10hrs PDT
Designed for an intent-based network, the Cisco Catalyst 8000 Edge Platforms family offers best-in-class networking and security combined. The platforms, available in b...