06-13-2009 01:34 PM - edited 03-06-2019 06:14 AM
Looking at configuring policing on a layer3 port on a 6500 switch. How do I calculate the burst rate to limit the port to allow a max of 600MB ingress/egress on a 1GB port
### 6500 ###
!- QOS
mls qos
!- ACL
access-list 101 permit tcp 172.16.35.152 0.0.0.0 172.18.0.0 0.0.0.255
access-list 101 permit tcp 172.16.38.100 0.0.0.0 172.18.0.0 0.0.0.255
access-list 102 permit tcp 172.18.35.125 0.0.0.0 172.16.0.0 0.0.0.255
access-list 102 permit tcp 172.18.38.100 0.0.0.0 172.16.0.0 0.0.0.255
!- class map
class-map Police
match ip address 101
match ip address 102
!- Policy map
policy-map Traffic
class Police_OUT
police 600000000 conform-act transmit exceed-act drop
Please advise.
!- L3 Port
int G5/1
service-policy in traffic
service-policy out trafic
06-13-2009 09:32 PM
I don't think the 6500 will support full MQC. Commands like police, bandwidth, etc. are not going to be taken.
Can anyone else confirm?
06-14-2009 06:16 AM
Sorry, just realized I gave you an answer that provided zero help. You will want to check out the 6500 documentation for PFC QoS. Specifically the sections for aggregate and micro-flow policers. Basically, you build the mls qos aggregate-policer, then apply that to the class-map.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide