05-06-2014 07:38 AM - edited 03-07-2019 07:20 PM
Hi All
Last week at a customer site we installed a 2nd 2960s 24 port switch to form a stack using flexstack cables, and the switch stack is working as expected as I can see a master switch and 2nd switch as a member.
For redundancy / resilience we decided to use port 24 on each switch over copper for trunk uplinks to our core switch. The issue that we're having is I can't ping the switch management address. I can however see the address in the arp table and the edge switch is visible when I run show cdp nei. As a work around I've shutdown one of the ports to the downlink from core to edge in order to ping the management address of the switch which is in vlan 1. I'd like to get the port-channel working on both sides for resilience.
ANY HELP IS APPRECIATED...
Core switch is a WS-C3750G-24TS-1U running software version C3750 Boot Loader (C3750-HBOOT-M) Version 12.2(25r)SEE4, C3750 Software (C3750-IPBASE-M)
Edge switch is a WS-C2960S-24TS-L running software version C2960S Boot Loader (C2960S-HBOOT-M) Version 12.2(53r)SE,C2960S Software (C2960S-UNIVERSALK9-M)
The config on the edge switch which goes to the core is :
interface GigabitEthernet1/0/24
description *****
switchport mode trunk
channel-group 6 mode on
end
interface GigabitEthernet2/0/24
description *****
switchport mode trunk
channel-group 6 mode on
end
interface Port-channel6
description ******
switchport mode trunk
end
The config on the downlink ports from the core to the edge:
interface GigabitEthernet1/0/20
description Edge
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 20 mode on
end
interface GigabitEthernet2/0/20
description Edge
switchport trunk encapsulation dot1q
switchport mode trunk
shutdown
channel-group 20 mode on
end
interface Port-channel20
description Edge
switchport trunk encapsulation dot1q
switchport mode trunk
end
Solved! Go to Solution.
05-07-2014 06:41 AM
In switch to switch channels I would use LACP or PAGP before hardcoding the channels on . Try one of those alternatives .
05-06-2014 01:40 PM
when using channel-group # on mode you must make sure the ports are on same duplex and speed setting
what happens when you use active mode?
05-07-2014 06:41 AM
In switch to switch channels I would use LACP or PAGP before hardcoding the channels on . Try one of those alternatives .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide