09-22-2011 10:33 PM - edited 03-07-2019 02:23 AM
Hi All,
Am using GNS3 software and have setup 2 cisco 3725 as below
R1 ---- portchannel 1------R2
the port channel is up but am not able to ping the link
am not sure if this is possible, because am not able to set the lacp protocol nor set the channel-group mode to enable
thank you very much for all the help....
09-23-2011 12:15 AM
Hi,
There is a restriction on configuring LACP/PAGP as they are not supported. Here is a good doc, thought of sharing with you.
http://www.cisco.com/en/US/prod/collateral/routers/ps5855/prod_white_paper0900aecd806f698a.pdf
Regards,
Sunil
PS: If you think the content of the post was useful, please rate the posting.
09-23-2011 03:35 AM
Thank you very much Sunil, just a few min back i realized this is not supported....but any idea how i can use 3750 or a L3 switch in GNS3 software....
thanks again for sharing the document...its very useful...
09-23-2011 04:33 AM
I guess it cannot be done. :-(
Regards,
Sunil
pls rate the helpful post.
09-23-2011 04:54 AM
Hi,
switching in GNS3 is done with a router equipped with an ethernet network module NM-16ESW but you are limited in what you can do, just a few unsupported features:
-port-security
-RSTP and MSTP and PVST(+)
-PagP and LACP
-DTP
...
Regards.
Alain.
09-23-2011 08:05 AM
Alain....thanks a lot for the information....cheers...
03-27-2012 11:41 AM
I could successfully experiment port-channel with a couple of c7200 direct connected at GNS3 .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide