08-22-2013 02:11 AM - edited 03-07-2019 03:04 PM
Hi All,
I just need to check which port my Wireless Access Point(WAP) is connected to on a switch.
When I run the following command I get the port channel no. but i need to know which physical port on a switch this WAP is connected to:
sh mac address-table | inc 000b.857b.39c0
1 000b.857b.39c0 DYNAMIC Po18
any help will be much appriciated.
Many thanks.
Solved! Go to Solution.
08-22-2013 03:25 AM
Hi Kamran,
I doubt your AP is connect to a switch via EtherChannel. the output of sh mac address-table suggests your AP is connect to a switch on the other end of Po18. Determine which switch this is and run your command when logged in there.
cheers,
Seb.
08-22-2013 03:25 AM
Hi Kamran,
I doubt your AP is connect to a switch via EtherChannel. the output of sh mac address-table suggests your AP is connect to a switch on the other end of Po18. Determine which switch this is and run your command when logged in there.
cheers,
Seb.
08-22-2013 04:13 AM
Hi Kamran,
with show ethercannel 18 summay you can see the physical ports bundeled in the EtherChannel.
show cdp neighbor
Btw: Instead of the pipe-include you can also use the command show mac address-table address 000b.857b.39c0
Hope that helps
Rolf
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide