ok i tried both commands. port security is not enabling (shows disabled in output) its cisco ip phone connected to port.
static and sticky
H(config-if)#$port-security mac-address 001E.13AF.893C
H(config-if)#no shut
H(config-if)#end
H#show por
H#show port-security in
H#show port-security interface g2/0/38
Port Security : Disabled
Port Status : Secure-down
Violation Mode : Shutdown
Aging Time : 0 mins
Aging Type : Absolute
SecureStatic Address Aging : Disabled
Maximum MAC Addresses : 1
Total MAC Addresses : 1
Configured MAC Addresses : 1
Sticky MAC Addresses : 0
Last Source Address:Vlan : 0000.0000.0000:0
Security Violation Count : 0
--------------------------
