port security with different MAC Address

[mohamed.fawzy2012]

there is problem as  the Configuration under interfaces with this commands ,

switchport port-security maximum 1
 switchport port-security violation shutdown
 switchport port-security mac-address sticky
 switchport port-security

Here the question if user put its PC’s port into switch port so this only pc will be learned on that port and if I changed the PC with another one it will block the port ,, what if I want to plug any pc on that port and to be  work , is that possible ? if yes ,how ?

[Reza Sharifi]

what if I want to plug any pc on that port and to be  work , is that possible ? if yes ,how ?

Yes, it is possible. Just remove this command from your config

no switchport port-security mac-address sticky

After removing this command, any PC can plug in to this port for a maximum of 1.

HTH

[mohamed.fawzy2012]

is that the only solution ?

[Reza Sharifi]

If you want any PC to be able to connect to that port, yes.

HTH

[cofee]

You can also add a limit to the switchport sticky command. Lets say you configure it to learn 3 mac addresses dynamically so after it hits that limit, the switch will not learn any more MACs on that switchport unless you manually delete one of the sticky mac addresses from that switchport.

Here is the command if it helps:

switchport port-security maximum 3