Power cables - For Cisco devices

[cknox1]

Hi All,

is there a specific link for where I can find out about the specific power cords which are needed for the devices, in terms of the correct part numbers etc....

I have a few devices which do not have cables, but I don't know where I can get the specific part numbers.....

Any help would be great!

[Seb Rupik]

Hi there,

Most enterprise cisco devices will have a hardware configuration guide, and a section dedicated to power supply installation. This will provide the information you are after.

What devices are you using?

cheers,

Seb.

[cknox1]

Hi Seb,

Thanks for the quick response - Unfortuanetly these devices are being re-used so the original boxes manufactures guide etc are not available.

Cisco 3560 Layer 3 switches and Cisco 2960 Switches - The cables are the same, but I just need the specific part number...

[Seb Rupik · Accepted solution]

If it is just the mains cable you are after, as a rule of thumb if the PSU is 350W+ it will need a "notched" cable aka, IEC C15 . Higher wattage PSUs will require a cable with a 13A rating, all others can use 10A.

For all lower wattage supply a standard IEC C13 cable will fit.

Cisco won't list part numbers for these cables as they are so ubiquitous. If they did have a part number I would be terrified to ask what the list price was! :)

cheers,

Seb.

[cknox1]

Hi Seb,

Thank you very much! This is what I was looking for c14 and c15 - That will do, as now I will just determine what the other end needs to be depending on what country they will be in.

Thank you very much for your help!

[Georg Pauwen]

Hello,

which country are you in ? Do you need the adapter AND the cable ?