ā03-23-2011 06:59 AM - edited ā03-06-2019 04:13 PM
Hi
I am facing an issue regarding power issoe on PoE ports. I am getting this log %ILPOWER-5-ILPOWER_POWER_DENY:
After checking cisco web site regarding same, I observe below output.
1. %ILPOWER-5-ILPOWER_POWER_DENY: Interface [chars]:inline power denied
This message means that the PoE request was denied because the switch does not have enough power left to support the request. [chars] is the interface number.
Recommended Action: No action is required.
Related documents- No specific documents apply to this error message.
So Please suggest me what to do now.. As earlier everything is working fine but after replacing the faulty switch with another switch, I observed this issue.
Should I raise the RMA for this switch or any way to troubleshoot this issue?
Please Help.
Thanks in advance,
Regards
Vinod.
ā03-23-2011 07:32 AM
are you seeing this issue on all the ports of the switch or on some ports...?
ā03-23-2011 10:16 AM
what are the results of your show power inline command? 3560's show available/used/remaining stats.
ā03-25-2011 12:05 PM
What do the POST startup tests show when you power cycle the switch?
ā03-28-2011 03:22 AM
Hi
ranraju @ :-- I am facing this issue only on few ports of the switch
Darren Willie @
When using show Power inline CLI.. MAx is 370 W consume 358 W Free 12 W.
Also when using show power inline status
many of the ports showing Cisco PD and consuming Max power (15.6 W)
stevenjwilliams83@----- I haven't test this till yet.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide