Privilege Levels

[Anand Narayana]

Privilege levels are from 0-15, where 15 is the full & 1 is the low & 5 is the medium, but what about the rest & also how do i make use of this in the Cisco ACS? because i am planning to make use of this privilege level in the group settings, like only some particular commands should be allowed for certain users using cisco ACS, so how do i do that?

[lgijssel]

Please check the link below for a few examples:

http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a008009465c.shtml

Regards,

Leo

[hardiklodhia]

Hi,

By default, there are three privilege levels on the router.level 1 ,15 ,0

you can make use of other levels by defining commands to that level by (for exp)

privilege exec level X configure terminal

for more details..

http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a008009465c.shtml

hope this will help.

rgrds,