05-13-2020 11:03 AM
Hi everybody,
I face a issue with a 2960L-48PQ-LL, i set a password for LinCon0 , Vty 0-15 and enable and do a Write. But i realize i dont have any username configure. I am locked beacause everytime i boot, the switch ask me for username. I do perform a password recovery but when system interrupt i only see boot command, no Flash_init and no Load-Helper. Cisco username dont work. How can i do a factory reset on these switch?
Thanks for the help
05-13-2020 11:26 AM
Hi,
Try following this password recovery document.
HTH
05-14-2020 05:43 AM - edited 05-14-2020 06:30 AM
Thanks for the help
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide