05-25-2011 02:55 AM - edited 03-07-2019 12:40 AM
Hi there
I have just set up an 2 port etherchannel between my 3548XL and my 2960G, it all loks good but when I do a shut on int gi0/2 on the 3548XL the link goes down completly, should it not failover to the remaning link? Here is my config:-
3548XL
interface GigabitEthernet0/1
port group 1
switchport trunk encapsulation dot1q
switchport mode trunk
!
interface GigabitEthernet0/2
port group 1
switchport trunk encapsulation dot1q
switchport mode trunk
2960G
interface Port-channel1
switchport mode trunk
!
interface GigabitEthernet0/6
switchport mode trunk
channel-group 1 mode on
interface GigabitEthernet0/10
switchport mode trunk
channel-group 1 mode on
Thanks for any help
05-25-2011 05:00 AM
Working with 3500XL series can get a little tricky when it comes to etherchannels. Make sure you:
!--- First, shut down the secondary ports involved in the channel !--- and then enable them back when the configuration is complete on both switches.
05-25-2011 06:40 AM
Yup tried that after doing the config, no change.
05-25-2011 07:40 AM
none of these ports are in a monitoring (SPAN) session, correct?
05-25-2011 08:42 AM
No?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide