cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1642
Views
0
Helpful
1
Replies

Problem with Link Aggregation Sg350 and Synology NAS

Rduhb
Level 1
Level 1

I've created the bond on the NAS.  But after I configure the switch the NAS locks up.  At one point I see is "Failed To Establish ieee 802.3ad connection."  Removing the LAG gets the NAS back online.  I made sure LACP was enabled and the correct ports were selected on the switch.  The NAS and PC are on the same VLAN.  I tried enabling the VLAN option on the NAS but that completely locked it up and forced me to reset the box.  Wondering if anyone else had issues with a Synology (1522+) NAS and a Cisco SG350 switch.

 

1 Reply 1

At one point I see is "Failed To Establish ieee 802.3ad connection." 

seems like configurations are not done properly from NAS or switch. check below links.

https://www.youtube.com/watch?v=SyRF7_QdsBk&ab_channel=LawrenceSystems

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-350x-series-stackable-managed-switches/smb5098-configuring-link-aggregation-groups-on-the-sg350xg-and-sg550.html

 

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB