Hello,
I've configured NAT, but it is not working.
Could you tell me what is wrong with my configuration?
-------------------------------------------------------------------------
!
!
upgrade fpd auto
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname R1
!
boot-start-marker
boot-end-marker
!
logging message-counter syslog
!
no aaa new-model
ip source-route
no ip icmp rate-limit unreachable
ip cef
!
!
!
!
ip name-server 8.8.8.8
no ipv6 cef
!
multilink bundle-name authenticated
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
archive
log config
hidekeys
!
!
!
!
!
ip tcp synwait-time 5
!
!
!
!
interface FastEthernet0/0
ip address dhcp
ip nat outside
ip virtual-reassembly
duplex half
!
interface FastEthernet1/0
ip address 194.169.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex half
!
interface FastEthernet2/0
ip address 194.169.2.1 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex half
!
router ospf 1
log-adjacency-changes
network 1.1.1.0 0.0.0.255 area 0
network 194.169.1.0 0.0.0.255 area 0
network 194.169.2.0 0.0.0.255 area 0
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
!
ip nat inside source list 1 interface FastEthernet0/0 overload
!
access-list 1 permit 194.169.1.0 0.0.0.255
no cdp log mismatch duplex
!
!
!
!
!
!
control-plane
!
!
!
!
!
!
!
gatekeeper
shutdown
!
!
line con 0
exec-timeout 0 0
privilege level 15
logging synchronous
stopbits 1
line aux 0
exec-timeout 0 0
privilege level 15
logging synchronous
stopbits 1
line vty 0 4
login
!
end
-----------------------------------------------------------------------------
Thank you,
Best Regards,
