Problems about Cisco 3845

[pchollatee]

Hi All Expert

     I found problem about cisco 3845 with

     Cisco IOS Software, 3800 Software (C3845-ADVSECURITYK9-M), Version 12.4(24)T, RELEASE SOFTWARE (fc1).

     Cisco 3845 (revision 1.0) with 1008639K/39936K bytes of memory.

     When I facing the problem it's can use only one command, "show version". other command not use and a result stop not complete but Cisco 3845 still alive not hang. This case effect with trafic.

     Any one found this case, please advice me.

[Leo Laohoo]

When I facing the problem it's can use only one command, "show version".

Can you get to enable mode?

[pchollatee]

@Leo Laohoo

     I can access to enable mode

[Leo Laohoo]

If you are in enable mode, please post the output to the command "sh proc cpu sorted 5sec | ex 0.00".

[pchollatee]

Cisco3845#sh proc cpu sorted 5sec | ex 0.00

no output, no anythinng after put the command

[Leo Laohoo]

Upgrade your IOS to something more recent.

[pchollatee]

which IOS version you recommend.

[Leo Laohoo]

I do not know your network.  So you'll need to decide.

[pchollatee]

Thank You Sir, I will find version that meet my requirement.