Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
FN - 72520 - Some Cisco DNA Center Appliances Shipped Between September 2022 and November 2022 Have Incorrect Firmware Installed - BIOS/Firmware Upgrade Recommended
Cisco 3850: IOS-XE/Firmware Upgrade
(Install Mode)
NOTE:
This procedure is aimed at Cisco 3850 switch ONLY.IOS-XE Bundle Mode is not covered. 9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered. Router(s) & switch(es) r...
NotesA Word from our Sponsors:Introduction:Section 1: General ProcedureSection 2: ROMMON UpgradeSection 3: Cellular Modem Firmware UpgradeSection 4: GOTCHA
Notes
This procedure is aimed at Cisco ISR 1k, ISR 4k and ASR 1k router ONLY.IOS-XE Bundle Mo...
@anshuman-kumar wrote:How to convert into IOS_XE
If the 917x is at the <Meraki> prompt, press at following keys at the same time Ctrl + Shift + 6, let go, and then press "x".
Wait for approximately 12 to 15 seconds for the Meraki mode to crash.
I...
Yes.
Sup32 and Sup720 (non-VSS), for example, came default (pre-CCW) with CatOS. There is a long-winded Cisco document to convert to Cisco IOS and I spent several days converting >20 line cards.
Look at the new Catalyst 9k switches, routers and Ca...
Is that the official answer, because, as we know, APDPs are basically a moot point since they were only used for 9130 and 9124!
@eglinsky2012,
That is the official role of the APDP. Whether or not WNBU &/or developers want to re-write the rules is ...
1. Copy the firmware into the active supervisor engine.
2. Copy the firmware into the stand-by supervisor engine.
3. Verify the firmware in the Active supervisor card is not corrupt: verify /md5 bootflash:filename.bin <md5 hash>
4. Verify the...