I wasn't really sure where to post this. I am trying to configure q-in-q on a 4331 running 16.9.4 (security and appx licenses) and it will not take the command.
(config-subif)#encapsulation dot1Q 100 ?
native Make this as native vlan
<cr> <cr>
The feature navigator says dot1q tunneling is supported on my IOS and hardware.
I am trying to configure something like this on a few subinterfaces.
interface g0/0/2
encapsulation dot1Q 100 second-dot1q 500
vrf forwarding FD-VRF
ip address 1.1.1.1 255.255.255.254
ip access-group VPN in