Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am relatively new to NDFC. I have some Palo Alto firewalls that are setup like below. VXLAN SW1 E1/10 <-> Palo Alto E1/1 - Palo Alto E1/2 <-> VXLAN SW2 E1/10VXLAN SW1 E1/11 <-> Palo Alto E1/3 - Palo Alto E1/4 <-> VXLAN SW2 E1/11 When we do th...
I am new to NDFC. I have my fabric built and switches discovered. I am trying to do the configuration but no matter what I am configuring I cannot 'deploy' the config. It is just not an option, more or less 'greyed out'. I can 'recalculate' after mak...
I am trying to come up with a way to have a single VPN0 interface template where I can do either auto or set a speed/duplex (some of our Internet circuits are required to be hard coded). I have tried a couple things unsuccessfully - the latest being ...
I am new to SDWAN. I am a little confused by VPN512 - What is it used for? Is it even needed for anything on the edge routers? Or can I just not use it and put a loopback in a service VPN for mgmt?
Does the SD-WAN remote access VPN support SSL VPN? I have seen a couple places in documentation that says it does but then everything else is only about IPsec VPN.
I did try a variable and it then has a drop down menu but auto is not an option in the drop down - just 10, 100, etc. They are 8200, 8300 and 1100X routers.
I understand it is used for out of band mgmt traffic. But for some reason I am very confused by it. I'm sure it is simple and I am overthinking it. Is VPN512 a flat network that all my devices would be on?Is it used for any communication between the...
