Question about the number of configurable static route on Catalyst 3750-X

[snakayama]

I have a question about the number of configurable static route on Catalyst 3750-X.

I found the following information on http://www.cisco.com/en/US/partner/prod/collateral/switches/ps5718/ps6406/data_sheet_c78-584733_ps10744_Products_Data_Sheet.html.

-　Static routing (16 routes) with LAN Base feature set.

However I can't find similar information about IP Base and IP Services feature set.

So if you have any information, please let me know about it.

Your information would be appreciated.

Regards,

[antonio.guirado · Accepted solution]

Hello,

Both ip base and ip services licenses have the same templates but different features. I send you

a link to check it:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6406/white_paper_c11-579326.html

c3750x use templates to optimize its works. So, you can select what template is better for your enviroment.

Static routes are unicast routes. I send you a link to check how many unicast routes are soported by each

template:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750x_3560x/software/release/12.2_58_se/configuration/guide/swsdm.html

Regards.

[shillings · Accepted solution]

With LAN Base, Cisco throw in capability for a very small number of static routes. They do this with their 2960 series layer-2 switches as well. Like Antonios says, the switch needs to be set to an approprirate SDM Template to access this limited routing capability. I think the default 3750-X template is the one you need.

With IP Base and above, you are opening up the switch's standard static routing capability. I'm sure there will be some static route limit, but it's going to be very very high - i.e. nothing like 16.

[snakayama]

Thank you very much for your reply.

Regards,