The following command is configured for policy-based NAT (source nat) with VRF under the following conditions.
Since it doesn't work properly, appreciate it if anyone could tell me how to fix.
L3SW
VRF name = VRF1000, Route-map name = NAT-MAP-1
Source = 192.168.1.1 (after NAT translation = 10.10.1.1), Destination = 192.168.1.2
[nat Configuration]
ip nat inside source static 192.168.1.1 10.10.1.1 vrf VRF1000 route-map NAT-MAP-1
[ACL Settings]
ip access-list extended 110
10 permit ip host 192.168.1.1 host 192.168.1.2
[route-map Settings]
route-map NAT-MAP-1 permit 10
match ip address 110