01-08-2019 12:15 AM - edited 03-08-2019 04:58 PM
1度、"service password-encryption"を入力すると、
"no service password-encryption"と入力しても、running-configでは暗号されたままになってしまうのですか?
復号された状態のrunning-configを表示させる方法はありませんでしょうか?
機器によっては復号されるものもあるのでしょうか?
packet tracerを使用し、2960-24TTで以下のコマンドを打ちました。
----------------------------------------
Switch>
Switch>ena
Switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
Switch(config)#ena
Switch(config)#enable pass
Switch(config)#enable password cisco
Switch(config)#
Switch(config)#service password-encryption
Switch(config)#no service password-encryption
Switch(config)#
Switch(config)#end
Switch#
%SYS-5-CONFIG_I: Configured from console by console
Switch#
Switch#sh run
Building configuration...
Current configuration : 1109 bytes
!
version 12.2
no service timestamps log datetime msec
no service timestamps debug datetime msec
no service password-encryption
!
hostname Switch
!
enable password 7 0822455D0A16
!!
!
-----------------------------
宜しくお願い致します。
01-08-2019 12:38 AM
Hi,
once you encrypted the password, you cannot decrypt it by entering 'no service password-enc'. you can use decryption tools to view password if you need.
regards,
01-08-2019 01:21 AM
thank you for answering
01-08-2019 01:21 AM
01-08-2019 01:55 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide